This article mainly introduces:

Australia hydraulic cylinder,servo cylinder manufacturer,servo cylinder

(Australia servo cylinder,produced by Hengyu Group）

servo cylinder are widely used in Australia，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed servo cylinder for customers from Australia.

Introduction to servo cylinder:

If the servo cylinder piston rod is found to be worn, it can be brushed and plated first, then ground, and finally adjust the mating accuracy of the piston rod and the guide sleeve. At this time, the guide sleeve can be properly redrilled or the guide sleeve can be re-turned. When making the above repairs, remember to replace various rubber seals in time.

When the servo cylinder is disassembled due to oil leakage and other faults, the position of the piston should be moved to any end position of the servo cylinder by applying liquid pressure. Improper tapping and sudden drop should be avoided during disassembly.

After the servo cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.

When the servo cylinder needs to be disassembled for maintenance due to leakage and other faults, the piston should be moved to the bottom position of the servo cylinder, and hard beating and sudden drop are strictly prohibited during disassembly.

Answers to some questions about servo cylinder:

How to distinguish large cavity and small cavity of excavator rod cylinder ?
Single rod piston cylinder is a form of cylinder that is used relatively most, and the boom, bucket, dozer shovel cylinder are all in this form. Among them, the rodless cavity is also called the large cavity, and the rodless cavity is also called the small cavity. Therefore, the cylinder cavity on the side with the exposed piston rod is the small cavity, and the cylinder cavity on the side without the exposed rod is the large cavity.

Two cylinders have a reversing control, if the load of the two cylinders is not the same, how to ensure their synchronization?
The piston rod of the cylinder is required to extend synchronization: install A shunt collector valve or synchronous motor at port A of the direction control valve, and then connect the two outlets of the shunt collector valve to the rod-free cavity of the two cylinders respectively. It is required that the outlet of the diverter collector valve is connected to the rod cavity of the two cylinders respectively when the piston rod is withdrawn in synchronization. The synchronization performance depends on the quality of the diverter valve and the leakage of the hydraulic system.