This article mainly introduces:

Ecuador hydraulic cylinder,steel mill cylinder manufacturer,steel mill cylinder

(Ecuador steel mill cylinder,produced by Hengyu Hydraulic Cylinder Factory）

steel mill cylinder are widely used in Ecuador，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed steel mill cylinder for customers from Ecuador.

Introduction to steel mill cylinder:

The definition of the minimum stable speed refers to the minimum movement speed of the steel mill cylinder without crawling phenomenon when the full load is moving, it has no uniform indicator, and the steel mill cylinder that undertakes different work has different requirements for the minimum stable speed.

steel mill cylinder can not drive the load troubleshooting: oil pressure is too low. steel mill cylinder selection specifications are too small. Leakage in steel mill cylinder or associated hydraulic system element.

The steel mill cylinder is not the same as the steel mill cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the steel mill cylinder can not be used as a high-power power component, but the steel mill cylinder can be used as a relatively large power component, or the steel mill cylinder system can be used.

The definition of the minimum starting pressure of the steel mill cylinder refers to the minimum working pressure of the steel mill cylinder in the no-load state, which is a comprehensive index reflecting the manufacturing and assembly accuracy of the steel mill cylinder parts and the size of the sealing friction.

Answers to some questions about steel mill cylinder:

How many tons is the oil cylinder 16mpa?
It depends on the cross-sectional area of the cylinder A(mm2)F=16mpa×A unit is (tons).

Why should the piston rod of the hydraulic cylinder be so precise? If you hope the cylinder has a long service cycle, then all parts need to be high-precision, not only the piston rod, but also the cylinder, the sealing groove, the surface roughness, the cylinder looks very simple. Any hydraulic factory can produce the cylinder, but the good cylinder is difficult to produce.