This article mainly introduces:

Cote d 'Ivoire hydraulic cylinder,trailer hydraulic cylinder manufacturer,trailer hydraulic cylinder

(Cote d 'Ivoire trailer hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

trailer hydraulic cylinder are widely used in Cote d 'Ivoire，because of long service life，smooth movement，high work efficiency.So our company has designed trailer hydraulic cylinder for customers from Cote d 'Ivoire.

Introduction to trailer hydraulic cylinder:

When the control pressure of the hydraulic system is too low, the trailer hydraulic cylinder will appear wrong or no action, because the throttle resistance in the control pipeline may be too large, the flow valve is improperly adjusted, the control pressure is inappropriate, and the pressure source is interfered with. At this time, check the control pressure source to ensure that the pressure is adjusted to the specified value of the system.

In the process of using the trailer hydraulic cylinder, sometimes such a problem will occur, the trailer hydraulic cylinder can not act immediately after the instruction of the trailer hydraulic cylinder action is issued, and it must be moved after a short time, or sometimes it can move and stop moving, showing that the operation is very irregular. The cause and elimination of this failure mainly include air in the oil trailer hydraulic cylinder. Elimination method: exhaust through the exhaust valve. Check the piston rod reciprocating parts of the sealing ring for air inhalation, if so, replace the sealing ring.

Before the trailer hydraulic cylinder is removed, the system should be unloaded, the loop pressure is zero, the oil source should be cut off, and the oil port should be blocked after the oil port distribution pipe is loosened.

trailer hydraulic cylinder installation precautions: Before installing the trailer hydraulic cylinder into the system, the parameters on the trailer hydraulic cylinder label should be compared with the parameters when ordering. The base of the trailer hydraulic cylinder must have sufficient stiffness, otherwise the trailer hydraulic cylinder will bend upward into a bow when pressurized, so that the piston rod will bend.

Answers to some questions about trailer hydraulic cylinder:

Why can't the hydraulic cylinder be pulled back after pushing to the limit?
May be long-term use to the limit position, resulting in serious wear caused! The solution is to add the stroke switch or disassemble and add gaskets before and after the piston.

How is the hydraulic cylinder selected in the mechanical design manual?
First of all, it is necessary to meet your work needs, and the second is to meet the structural space of the cylinder and accessories. Three to consider the other parameters of the cylinder.