This article mainly introduces:

Qatar hydraulic cylinder,displacement sensor cylinder manufacturer,displacement sensor cylinder

(Qatar displacement sensor cylinder,produced by Hebei Hengyu company）

displacement sensor cylinder are widely used in Qatar，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed displacement sensor cylinder for customers from Qatar.

Introduction to displacement sensor cylinder:

displacement sensor cylinder can not drive the load troubleshooting: oil pressure is too low. displacement sensor cylinder selection specifications are too small. Leakage in displacement sensor cylinder or associated hydraulic system element.

When the displacement sensor cylinder is installed, it is necessary to ensure that the direction of the connecting head at the top of the piston rod should be consistent with the direction of the displacement sensor cylinder head, earring (or middle hinge shaft), and ensure the straightness of the whole piston rod during the advance and return process to prevent rigid interference and cause unnecessary damage.

displacement sensor cylinder daily maintenance, should focus on checking whether the piston rod surface roughness and shape and position tolerance meet the technical requirements, if the piston rod bending should be calibrated to meet the requirements or according to the physical mapping, manufactured by a professional manufacturer. If the piston rod surface coating wear, slip damage, local spalling can be adopted to remove the coating, re-chrome surface processing process.

displacement sensor cylinder buffer valve inspection and maintenance: For the valve buffer displacement sensor cylinder, the focus should be on checking the wear of the buffer valve spool and seat. Once it is found that the amount of wear increases and the seal fails, it should be replaced. It can also be repaired by using abrasive spool and seat matching grinding method.

Answers to some questions about displacement sensor cylinder:

Hydraulic system schematic diagram, pipeline identification S and L, respectively corresponding nominal diameters? 16S is equivalent to DN12 high-pressure cylinder, and 15L means what?
16S refers to the high pressure series, outer diameter 16x2 steel pipe, the corresponding sleeve nut is M24X1.515L is the low pressure series, the outer diameter of 15x1.5 steel pipe, the corresponding sleeve nut is M22X1.5.

How does the one-way solenoid valve control the hydraulic cylinder circuit?
If your cylinder is single-acting, you can use a one-way solenoid valve, such as some lifting platform hydraulic cylinder, the support valve used is one-way (two-position tee), that is, the cylinder extends out by the oil pressure top, the cylinder retracted by its own weight.