This article mainly introduces:

Canada hydraulic cylinder,automatic reversing cylinder manufacturer,automatic reversing cylinder

(Canada automatic reversing cylinder,produced by Hebei Hengyu company）

automatic reversing cylinder are widely used in Canada，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed automatic reversing cylinder for customers from Canada.

Introduction to automatic reversing cylinder:

The oil automatic reversing cylinder is a part of the hydraulic system, in the hydraulic system, to reasonably design the heat dissipation system, to prevent the oil temperature is too high is the key to keep the hydraulic oil temperature normal. The temperature of the system should be kept in a suitable range to reduce the energy released when the bubble bursts. While not affecting the normal circulation of the coolant, a certain amount of anti-corrosion additives can be appropriately added to inhibit rust. When operating the hydraulic system, we should strive to be stable, not too fast, too strong, and try to reduce the impact of hydraulic oil on hydraulic components.

The difference between the integral automatic reversing cylinder and the split automatic reversing cylinder: The integral automatic reversing cylinder and the split automatic reversing cylinder in the automatic reversing cylinder are two different automatic reversing cylinders, and they are very different. The whole automatic reversing cylinder, which is cast in one body, is not prone to problems such as oil leakage; The split automatic reversing cylinder is welded twice, so if it is not handled well at the welding, it is prone to problems such as oil leakage and automatic reversing cylinder damage. Therefore, it is obvious that the answer to this question is for difference.

When the automatic reversing cylinder is in use, once the seal and guide support ring are found to be defective, the seal with the same structural form and appropriate material should be replaced according to the structural form of the automatic reversing cylinder seal to be repaired, so as to minimize the thickness of the oil film between the seal and the sealing surface and reduce the leakage of the seal.

Classification of automatic reversing cylinder: according to the mode of movement it can be divided into linear reciprocating movement type and rotary swing type; According to the effect of liquid pressure, it can be divided into single acting type and double acting type. According to the structure, it can be divided into piston type, plunger type, multistage telescopic sleeve type, pinion and rack type, etc. According to the installation form can be divided into rod, earring, foot, hinge shaft and so on; According to the pressure grade can be divided into 16Mpa, 25Mpa, 31.5Mpa and so on.

Answers to some questions about automatic reversing cylinder:

What are the standard cylinder models for hydraulic cylinders?
National standard GB/T2348-1993 specifies the hydraulic cylinder inner diameter series, you can check GB/T2348-1993 relevant regulations.

Why is the cylinder not in place when the concrete pump truck changes the piston?
When the concrete pump truck changes the piston, the cylinder is not in place mainly because the transfer oil connecting the two cylinders is not completely drained. Sany and Zhonglian have a piston return switch, which can be used to back the piston to the cleaning tank. The elephant is equipped with a stop valve at the bottom of the oil cylinder, usually in the closed state, when opened, the piston can be returned to the cleaning tank, remember to close the valve after the piston is updated.